Installation Guide

Classic owner’s manual Rev I 2193
14 |
P a g e 1 0 - 0 0 1 - 1 R E V : I
Removing and installing the front cover on the Classic
Removing the front art deco cover is required to gain access to the wiring compartment.
Be aware if this is not the first removal of this cover there is a cable connecting the cover to the
electronics. Do not pull hard or fast as damage could occur.
To remove the front cover of the Classic in preparation for installation, remove the 4 Phillips head screws
with a #2 Phillips screwdriver. Lift the front half of the Classic casting off. You will need to unplug the
display cable. It works the same as any phone cable.
When installing the cover for the final time, squeeze a small amount of Silicone grease (Included in the
parts bag) onto the metal pins of the male jacks on the Display cable before plugging them in.
To re-install the front cover of the Classic you will need to plug in the display cable and carefully route it
around the components on the circuit board as you set the cover in place. See Figure 2 Do not force the
cover if it does not seat into place easily stop and look for any cables or wires that may be interfering.
With the cover seated in place install the four Phillips screws with a #2 Phillips screwdriver.
Figure 2