User Guide

English - 4
003-10007-99 © Midmark Corporation 2017
Important Information
Safety Instructions
The primary concern of Midmark is that this equipment is operated and maintained with the safety of the
patient and sta󰀨 in mind. To assure safe and reliable operation:
• Read and understand this manual before attempting to setup or operate the ultrasonic.
• Assure that the appropriate personnel are informed on the contents of this manual.
(This is the responsibility of the purchaser).
• Assure that this manual is located near the ultrasonic.
Equipment Alert
• Do not operate the ultrasonic cleaner dry. Ensure that the bath contains water-
based solutions before use.
• Always ensure the liquid is above the level sensor when in operation.
• Do not place parts or containers directly on the bottom of the cleaning tank;
always use a basket to suspend items. Failure to comply may cause damage
to the transducers and will void your warranty.
• Do not place hands or fingers in the tank. Doing so may cause discomfort and
possible skin irritation. Avoid contact with solutions.
• Do not move the ultrasonic when it contains water.
• Do not put hot water above 122°F (50°C) into the ultrasonic.
• Never use alcohol, gasoline or flammable solutions in your unit. Doing so may
cause a fire or explosion and will void your warranty.
• Do not use mineral acids. These could damage your tank.
• Do not use solutions containing chlorine bleach
• Only a certified service technician should dissemble the unit should it be
needed.
Caution
To avoid electrical shock:
• The power plug/appliance inlet is the disconnect device. Position the ultrasonic cleaner
so that the power cord is easily accessible.
• The power cord supplied with the Ultrasonic cleaner is rated at 10amps. Do not t a
power cord rated to less than 10amps
• Do unplug from power source before lling or emptying the tank
• Do keep the control panel and area around the cleaner clean and dry – wipe up solution
which spills over the tank brim. Water and high voltage can cause electrical shock.
• Do not operate the cleaner without proper grounding
• Do not remove the grounding prong on the line cord plug.
• Do not immerse the cleaner in water.
Subjecting the bath to improper treatment or misuse will invalidate the warranty.