User Guide

English - 13
003-10007-99 © Midmark Corporation 2017
During Operation
• When the QuickClean™ is in operation, the following screen will display.
• The actual time will be the time set by the operator and count down in 1 minute
increments.
• The temperature shown is the actual liquid temperature, and will increase with use.
• The operator can abort the cycle at any time by pressing the
 left arrow key “ABORT”
• If the temperature reaches 140F/60C the unit is too hot. The unit will automatically
abort the cycle and you will receive an ABORT - OVER TEMP message.
(Refer to the
Troubleshooting & Problem Solving Section).
Successful Completion of Cycle.
A) On successful completion of the cycle, the below message will display until the operator
presses CONTINUE.
B) Remove the basket from the bath, rinse and inspect after cleaning
C) Your QuickClean™ remembers the set parameters from the previous cycle. If the opera
tor wants to run the same cleaning cycle press CONTINUE. It is not necessary to run
through the menu each time.
D) Your unit is factory preset to run a 10 minute cycle.
Note
The lid can be inverted and the basket placed
on top to catch excess liquid.