Specifications

SECTION IV
MAINTENANCE / SERVICE
Figure 4-27. Display PC Board Lamp / Display / Button Check
(M9 / M11 shown)
NOTE
After the following step is performed, the display PC
board lamps will individually illuminate and then
extinguish one at a time in a left to right sequence.
When all the lamps have illuminated and extin-
guished, proceed with step 4.
(3) Press and hold down the LIQUIDS and PACKS
buttons simultaneously while connecting the
power cord to the sterilizer (See Figure 4-27).
Release the LIQUIDS and PACKS buttons.
NOTE
When each button is pressed, its corresponding lamp
will illuminate and stay illuminated. Also, after the
following step, the PRESSURE (PSI) display will
display the pressure that the control PC board is
reading and the TEMP (°F) / TIME (MIN: SECONDS)
display will display the temperature that the control
PC board is reading. When each button has been
pushed, proceed with step 5.
(4) Press and release the UNWRAPPED,
POUCHES, LIQUIDS, PACKS, START, STOP,
AND ON/STANDBY buttons one at a time and
in this order.
4.24 Pressure / Temperature Potentiom-
eters Adjustments
EQUIPMENT ALERT
The pressure zero, pressure range, and
temperature potentiometers cannot be
adjusted separately. If one potentiometer needs
adjusted, then the entire potentiometer adjustment
procedure must be performed, and it must be per-
formed in the proper sequence as follows:
(1) Remove right hand side panel.
(2) Open sterilizer door.
DANGER
The following steps require the steril-
izer to be plugged in to power while the
adjustment is being performed. Do not touch any
components except for the adjusting screw of the
potentiometer. Failure to comply with these
instructions could result in an electrical shock,
which could result in severe personal injury or
death.
© Midmark Corporation 2002 SF-1827 Page 4-20 Printed in U.S.A.
MA207701
ON/STANDBY
ERROR
STOP
DOOR AJAR
START
WATER LOW
PACKS
COMPLETE
LIQUIDS
DRYING
POUCHES
STERILIZING
UNWRAPPED
FILLING
PRESSURE (PSI)
TEMP ( ° F) \ TIME (MIN : SECONDS)
TEMP / TIME DISPLAY
LAMP
LAMP
PRESSURE
DISPLAY
UNWRAPPED
BUTTON
POUCHES
BUTTON
LIQUIDS
BUTTON
PACKS
BUTTON
START
BUTTON
STOP
BUTTON
ON / STANDBY
BUTTON
Return To Table Of Contents