Specifications

SECTION I
GENERAL INFORMATION
© Midmark Corporation 2002 SF-1827 Page 1-4 Printed in U.S.A.
Table 1-2. Special Tool List
Description of Special Tool
Manufacturer’s
Name / Address / Phone
Manufacturer’s
Part Number
Purpose of Special Tool
Digital Multimeter (must be
capable of displaying 3 digits)
Commercially Available Any Type Used to check probes, switches, and connections
for proper function by performing continuity
checks.
Water Level Sensor Wrench Midmark Corp.
60 Vista Drive
Versailles, Ohio 45380
[phone]
050-2324-00 Used to hold fitting in place so the nut that holds
water level sensor can be loosened / tightened.
3/32 in. Diameter Punch Commercially Available Any Type Used to remove / install two roll pins which secure
door switch in place or roll pin which secures latch
lever to pulse solenoid.
Pressure Gauge Test Harness Midmark Corp.
60 Vista Drive
Versailles, Ohio 45380
[phone]
002-0372-00 Used to check the pressure in the pressure vessel
during a cycle to diagnose malfunctions and / or
adjust the pressure range potentiometer to a
correct setting.
1.4 Ordering Parts
Contact Midmark's Technical Service Department with
all necessary information (model / serial number, part
number, etc.).
Orders can be placed using the Fax Order Form ( page
7-2) or by calling the phone number on the back cover of
this manual.
1.5 Special Tools
Special tools needed to repair the sterilizer are listed
below in Table 1-2.
Figure 1-4. Major Components
HEATING
ELEMENT
PRESSURE
RELIEF VALUE
BELLOWS
ASSEMBLY
CONDENSING
TANK ASSEMBLY
CONDENSING TANK
WATER LEVEL SENSOR
(early M9 only)
TEMPERATURE
SENSOR ASSEMBLY
PRESSURE VESSEL
WATER LEVEL SENSOR
VENT
SOLENOID
DISPLAY PC
BOARD
PRESSURE
VESSEL
DOOR
SWITCH
PULSE
SOLENOID
CONTROL PC
BOARD
THERMOSTAT
FILL
SOLENOID
MA207604
(M9 / M11only)
Return To Table Of Contents