Specifications

37
Removing the Paper Roll
Before removing the paper roll, advance the paper about 2.5 cm (1 in.) beyond
the paper cutter by pressing down and holding the switch to the ON / FEED po-
sition. Lift the paper roll away from the printer housing, and with a scissors, cut
the paper roll feeding to the printer. Try to make the cut as straight as possible
to facilitate the next reloading of the paper. Now, pull the remaining paper
through the printer mechanism.
Power Up Message
When the printer is first turned on, it prints the word READY to assure the oper-
ator that its built in microprocessor is working properly. When turning the printer
OFF, wait at least 3 seconds before turning the printer back on.
Printer Tape Description
The printer will print the following information for each program cycle:
Set Temperature
Set Time
Run Number
Date: a blank line is printed so that the date can be recorded on the printer tape.
The printer will print the chamber temperature, the chamber pressure, and the
time elapsed in two (2) minute increments during the heat up phase.
During the actual Sterilization Phase of the program cycle, the printer will record
the chamber temperature, chamber pressure, and the time elapsed for each
minute of the program cycle.
When the sterilizer has completed the Sterilization Phase of the program cycle,
the printer will print the word VENT to show that the steam pressure was ex-
hausted from the chamber.
When the sterilizer has completed the Drying Phase of the program cycle, the
word COMPLETE will be printed to show that the sterilizer has completed the
sterilization program cycle.
EQUIPMENT ALERT
Be sure to pull the paper out of the top of the printer (paper cutter
side). Pulling the paper out of the back of the printer will damage
the printer mechanism.
Return To Table Of Contents