Specifications

8
TP202 Rev. A © Midmark Corporation 2013
Controls & Indicators
Thesterilizercontrolsandindicatorsareshownintheillustrationsonthis,andthefollowingpage.
Theaccompanyingtablesdescribethefunctionofeachcontrol/indicator.
Control Function
Display see illustration Indicatescycleselected,cycletemperatureandexposuretime
fortheselectedcycle.Duringthecycle,displayshowsmessages
describingstatusofcycle.Whencycleenterssterilizationmode,
remainingcycletimeisdisplayedaswellastemperatureand
pressure.Displayalsoshowserrormessageifamalfunction
occurs. Refer to the Troubleshooting section of this manual for a
detailedexplanationof Informational / Error Messages.
Unwrapped button
Aprogramcycledesignedtoprocessunwrappedinstrumentsat:
270° F (132° C) for 3:00 minutes / 30 minute drying cycle.
Pouches button
Aprogramcycledesignedtoprocessinstrumentsincombination
paper / plastic sterilization pouches or wrapped instruments at:
270° F (132° C) for 5 minutes / 30 minute drying cycle.
Packs button
AProgramcycledesignedtoprocesspacksofinstrumentsat:
250° F(121° C) for 30 minutes / 30 minute drying cycle.
Handpieces
button
Aprogramcyclefordentalhandpieceswhichrunsat:
270° F(132° C) for 6 minutes / 30 minute drying cycle.
Start button
Initiatesselectedprogramor,whenSELECTCYCLEisdisplayed,
pressingStart will activate heater for 10 minutes.
Stop button
Terminatesselectedprogramorfunction.
1 or 2 buttons
NOTE:Allmaterial
run in these cycles
must be validated
for sterilization by
the user.
Programmablecyclebuttonsthatallowsanoperatortocreatetwo
differentprogrammedcyclesforspecialapplications.Sterilization
timeandtemperature,alongwithdryingtimeandventingproce-
durecanbeadjustedorchanged.