Specifications

42
The figure below shows an example of a typical printout of a program cycle:
Midmark M9 - v1.0.3
Total Cycles: 10
- - - - - - - - - - - - - - - - - - -
Sterilizer ID
- - - - - - - - - - - - - - - - - - -
Operator
- - / - - / - - - - - - : - -
mm / dd / yyyy hh : mm
BEGIN UNWRAPPED CYCLE
Temp: 270 Degrees F
Time: 3 Minutes
Dry: 30 Minutes
FILLING CHAMBER
HEATING
mm:ss Degrees PSI
0:00 233.8 F 0.0
0:30 231.3 F 1.9
8:00 265.7 F 25.0
8:30 271.3 F 28.8
STERILIZING
mm:ss Degrees PSI
0.00 271.8 F 28.9
0:30 272.4 F 29.5
2:30 272.7 F 29.3
3:00 272.6 F 29.3
Min 271.8 F 28.7
Max 273.2 F 29.9
VENTING CHAMBER
DRYING
mm:ss
0:00 Drying Start
5:00
25:00
30:00 Drying Complete
FILLING: 3:22
HEATING: 8:54
STERILIZING: 3:00
VENTING: 2:16
DRYING: 30:00
TOTAL CYCLE: 00:47:32
CYCLE COMPLETE
These lines don’t print
if Dry Cycle is aborted
before it completes.
Cycle
Summary
These lines will show the
total Dry time completed.
During Drying phase
the printer records
drying time in 5
minute increments.
Summary of
Sterilization phase.
Indicates Chamber
filling phase initiated.
Selected Cycle
Line provided for
Operator Signature.
Total # of cycles
run on unit.
Indicates venting
phase initiated.
During Sterilization Phase
the printer records chamber
temperature & pressure in
30 sec. increments.
During Heat-Up Phase,
the printer records chamber
temperature & pressure in
30 sec. increments.
Sterilization temperature
& time, and Dry time
set points.
Space provided for
recording date & time.
Line provided for
sterilizer identification.