Specifications

9. Turn the paper roll so as to take up the slack in the paper feeding to the

printer. Make sure the roll of paper turns freely. If it does not turn freely, the

paper will jam and possibly damage the printer mechanism.

10. Install the printer assembly (1) back into the printer cavity (A).

About the Cartridge Ribbon

The printer takes a cartridge ribbon. If the printed material is difficult to read

and you suspect a dried out ribbon is the cause of the problem, advance to a

properly inked portion of the ribbon by pressing the PAPER FEED button for

three seconds. When printing becomes faint or difficult to see and pressing the

PAPER FEED button for three seconds does not correct the problem, you

should replace the cartridge (see Installing a New Cartridge Ribbon later in this

manual).

Installing a New Cartridge Ribbon

1. Unplug the sterilizer power

cord from electrical outlet.

2. Remove the printer assembly

(1,Figure 5) from the printer

cavity (A).

3. Separate the printer (2) from

the cover (3) by slightly bend-

ing the housing (B) to release

the locking tabs (C)

4. Push down on side of printer

cartridge (4) marked EJECT

and remove the old ribbon car-

tridge.

5. When installing the new car-

tridge be sure the ribbon is

inserted in front of the paper

and flat against the paper

Press the ribbon cartridge (4)

downward until it snaps into

place.

6. Turn the knob (D) on the rib-

bon cartridge clockwise until

ribbon is tight.

7. Re-attach cover (3) to printer

(2) by inserting locking tabs (C) into slots of housing (B).

8. Place printer assembly (1) in cavity (A).

9. Plug sterilizer power cord into electrical outlet.

EJECT

Figure 5