Specifications

Inserting the Paper Roll

1. Remove the

printer assem-

bly (1,Fig. 4)

from the printer

cavity (A) and

turn it onto its

back.

2. Remove paper

spindle (2) from

used paper roll

and insert it in

new paper

roll (3).

3. Unroll 2 to 3

in.(5 to 7.5 cm)

of paper (3).

4. Cut a straight

edge on the

paper (3) if it is

torn or jagged;

this will facili-

tate the entry of paper into the printer.

5. Slide the paper (3) into the slot (B) on the back of the printer; it will slide in 1/

4 in. (6.4 mm) before it stops.

6. While holding the paper (3) in place, press the PAPER FEED button (5) and

hold. The printer will activate and a rubber roller will pull the paper into the

printer compartment. Continue to hold the PAPER FEED button down until

the paper emerges from the top of the printer mechanism. Then, when 1 in.

(2.5 cm) of paper has emerged from the top of the printer, release the

PAPER FEED button.

7. Pull the paper (3) through the printer until 2 to 3 in. (5 to 7.5 cm) of paper is

exposed.

8. Install the paper roll (3) by inserting the ends of the paper spindle (2) in slots

of spindle holders (4).

NOTE

If paper (3) does not feed out of top of printer by itself, remove printer assembly (6)

from printer housing (7) by pulling two locking tabs (C) from locking slots (D). Feed pa-

per through paper slot in printer housing (7) by hand and then re-attach printer assem-

bly (6) to printer housing (7) by inserting two locking tabs (C) into locking slots (D).

MA465001i

Figure 4