Specifications

37
6. Route loose end of
PCB printer harness
(1, Figure 2) through
slot (A) in printer cav-
ity (4) of top cover.
7. Plug PCB printer har-
ness (1) into printer
terminal (2) of PC
Board.
8. Position printer
assembly (3) in
printer cavity (4).
9. Insert two tabs (A,
Figure 3) of right
hand side panel (1)
into slots (B) in
base (2).
10. Raise top edge of
right hand side panel (1) into
position under top cover (3)
and secure using two
screws (4) and one screw (5).
Make sure back lip of right
hand side panel is on outside
of back panel; not on inside.
11. Plug sterilizer power cord into
electrical outlet.
12. Insert a paper roll if necessary
(see Inserting Paper Roll later
in this manual).
Operating the Printer
When the sterilizer is plugged in,
the printer is automatically pow-
ered up and initialized; no user in-
tervention / setup is required.
R
1
3
A
MA595100i
4
2
Figure 2
3
4
5
B
A
1
2
Figure 3