Specifications

PRINTER INSTALLATION AND OPERATION

The printer is an optional add-on that some units may have. The printer may al-

so be purchased as an accessory at a later date and installed.

Installing the Printer

1. Unplug sterilizer power cord

from electrical outlet.

2. Using a flat bladed screw-

driver, carefully pry existing

printer cover plate (1, Fig. 1)

from top cover (2) and dis-

card (cover plate is held in

place with double sided

tape).

3. If not already assembled,

attach printer assembly (3)

to printer housing (4) by

inserting two locking tabs

(A) into locking slots (B). Set

printer assembly aside.

4. Remove two screws (5) and

one screw (6) securing right hand side panel (7).

5. Pull outward and down on top edge of right hand side panel (7) and remove

right hand side panel from sterilizer.

WARNING

Disconnect all

electrical power

to the unit before removing

any of the unit’s covers/

shrouds or making any re-

pairs to prevent possibility

of electrical shock. Failure

to comply with these in-

structions could result in

serious personal injury.

MA595000i

EJECT

Figure 1