User Manual

M3 Sterilizer - continued

Equipment Alert

The tank hose must be properly connected

(and not kinked). Improper connection will

cause water / steam leaks or a sterilizer

malfunction if water flow to the tank is restricted.

Note

External Condensing Tank is not needed if M3 is connected

to the VistaCool direct-to-drain thermal reduction system.

Connect the condensing tank.

A) If connected, disconnect sterilizer power cord.

B) Push tank hose into compression fitting on lid.

Tighten nut. (If step B is difficult - see NOTE)

C) Connect tank hose to back of sterilizer.

D) Fill condensing tank with tap water to minimum

water level indicator line.

E) Secure the lid on the condensing tank by aligning

the tabs and rotate lid clockwise to secure.

Note

If tubing is difficult to install.

A) Remove compression nut & two ferrules.

B) Install nut and ferrules onto tank hose as shown.

(Large & small ferrules must be positioned as shown)

C) Insert hose into tank fitting, then tighten nut.

Power Cord

Compression

Fitting

Tank Hose

Min. Water Level

Indicator Line

Ferrule

(small)

Ferrule

(large)

Nut

003-10351-00