User Manual

Voltage Rating

Connect power cord.

A) Plug power cord into receptacle on back of sterilizer.

B) Plug power cord into a properly polarized and grounded receptacle

rated for a minimum of 15 amps. A dedicated circuit only used for

the sterilizer is recommended.

C) M9 / M9D and M11 are not equipped with an on/off switch, the display

operates off very low power. (example: microwave oven display)

Note: When power is connected, the messages shown will appear on the display.

Fill reservoir.

A) Open door to unit.

B) Pour distilled water into fill opening until

water level reaches the top of the fill level

label on the water level indicator tube.

Equipment Alert

Use distilled water or water that meets the

water purity specifications referenced in

your Users Guide. Failure to comply may

result in sterilizer malfunction and/or premature

failure due to excessive corrosion.

M9 / M11 Steam Sterilizer - continued

Note

For M9-04x / M11-04x models, The User Settings mode will enable

the user to set the desired unit of measure and adjust the time clock.

Refer to “User Settings” in your User Guide.

M9-04x / M11-04x

Display Shown

* These screens will display the total number of cycles run on the unit, the

model number (M9/M9D or M11), the software version number, serial number

and M9/M11-04X models also display the date and time.

midmark.com

003-10351-00