User Manual

Degas

• Degas cycle will allow optimal ultrasonic activity by removing gases present in

ordinary tap water.

• The time needed to degas the liquid will vary depending on the amount of gas

present in the liquid and the quantity of water in the tank.

• A degas period of 5 to 10 minutes is recommended.

• During the degas cycle you will see bubbles of gas forming on the inside of the

ultrasonic bath and slowly rising to the surface, when you no longer see these

bubbles come to the surface you can end your degas cycle.

Running a Degas Cycle.

A) When the unit is powered on, when you change the solution or when the liquid has

fallen below the water level sensor you will receive the option to degas your ultrasonic.

B) Prior to starting the degas cycle, remove all instruments and make sure the unit is filled

with liquid and the required dose of cleaning solution.

C) Place the lid on the ultrasonic unit.

D) Select the upper < YES to start the degas cycle. The screen below will display

E) Once all the bubbles have come to the surface your degas cycle is complete.

F) Press the  left arrow SKIP to end the degas cycle. Your degas cycle will NOT

automatically stop when degassing has completed

QuickClean™ Units - continued

Degas Cycle

midmark.com

003-10351-00