User Manual

QuickClean™ Units

Close drain valve.

Ensure that the drain valve is in the Closed position.

Drain Valve Closed

Drain Valve Open

Before Operating the QuickClean™

A) Clean unit and wipe out tank. “Clean by wiping with a damp soapy cloth and rinse.”

B) Pour water into the bath so that it reaches the liquid level sensor, but do not exceed the

maximum fill level. Follow cleaning agent’s recommendations on water temperature.

Cleaning efficacy can only be guaranteed if the water temperature is at least 70 F.

C) Add the required dose of cleaning agent. Follow cleaning agent and instrument

manufacturers’ recommendations for acceptable cleaners and concentrations.

To accommodate for tank size round up the amount of cleaning agent to the nearest

1 oz/gal, 10 ml/l or 10 gram/l.

D) Turn on the machine via the switch at the rear of the unit, just above the power cord.

The switch will then illuminate.

E) Run a Degas Cycle.

ON/OFF Switch

(Push Button)

Bath Fill

Line

Water Level

Sensor

Max Fill Level

Main Power

Connection

Connecting the power cord.

A) Plug the power cord into the main power connection

located on the back of your unit

B) Ensure your QuickClean™ ultrasonic bath is plugged

into a 115 VAC fully grounded outlet.

003-10351-00