User Manual

Specifications
The wireless control’s “association” is preset at the factory.
This procedure is only required if there is a malfunction, or if you
are attempting to use the controller with a chair other than the one
it was originally associated with.
Troubleshooting
• When any control button is pressed, that controller
sounds a single “beep”. (All functions operate)
Cause: Low Battery
Solution: Replace batteries
• When any control button is pressed,
nothing happens. (No “beeps”, no movement, etc.)
Causes: 1. Batteries completely dead
2. Wireless controller has lost
“association” to chair.*
Solution: 1. Replace batteries
2. Perform Association Procedure*.
* The wireless controller will only function with the
chair it has been “associated” with. This
prevents unwanted movement in locations with
more than one chair.
If further service is required,
contact your authorized Midmark dealer.
Association Procedure:
A. Using the wired hand control, press & hold
the Stop & Home buttons simultaneously.
(after two seconds you will hear a single “beep”)
B*. Using the wireless hand control, press & hold
the Stop & Home buttons until you hear three “beeps”.
(one long “beep” indicates the association failed. Repeat Steps A & B)
C. Check for proper operation of wireless hand control.
* Note: Step B must be performed within 10 seconds of Step A,
failure to do so will cause the procedure to fail.
Range of Operation ................. 20 ft (6 m) radius
Batteries:
Hand Control ......................... AA (qty: 2)
(Note: Battery access cover is located on back of controller)
DA191300i