Service manual

IQmark Digital Spirometer Operation Manual

Thin Client Channel Setting

The Thin Client Channel setting applies only if you are using the IQmark Diagnostic

Workstation in a thin client environment. This setting is ignored when the software is not

running in a thin client environment. The drop down combo box contains the following

selections.

1. COM port mapping (default)

2. Microsoft RDP

3. Citrix

Select “COM port mapping” if you are using the IQmark Diagnostic Workstation product

in a thin client and are not using the IQmark Virtual Channel Solution. If you are using

the IQmark Virtual Channel Solution, select Microsoft RDP if your clients and servers are

using Microsoft Terminal Services or select Citrix if your clients and servers are using

Citrix software. Please refer to the document entitled “Application Note: Using the

IQmark Thin client Virtual Channel Software” for more information.

Configuration Profile

Click the Add New button in the Configuration Profile area of this tab. Assign a name,

e.g. My Config, and click OK. You can now modify the selections in the setup menu.

Changing the Institution Name and Institution Address will change the header of your

reports. Both fields are optional.

 NOTE: The original configuration profile may be set to Default. The Default

profile cannot be changed. You must click the Add New button to create

a new profile to change these settings. Once a new profile is added, you

can change the settings on the other tabs. Other preset profiles are shipped

with the instrument. Any of the other profiles can be modified or deleted.

Back

Go To Table Of Contents