Service manual

IQmark Digital Spirometer Operation Manual
3
Network
Terminal Server
Windows Client PC
Windows Client PC
USB
Or
Serial
IQmark Digital
Spirometer
Windows Client PC
To use the IQmark Virtual Channel Solution, load the IQmark Diagnostic Workstation
software on the terminal server and install one of the following software components on
each Windows client PC that you intend to use for Spirometry data acquisition.
1. IQmark Virtual Channel Client for Microsoft Terminal Services (part number 4-
100-1420) if you are using Microsoft Terminal Services (also called Microsoft
RDP).
2. IQmark Virtual Channel Client for Citrix ICA (part number 4-100-1430) if you are
using Citrix software on your clients and servers.
The above software products are provided separately and may be obtained by contacting
Midmark Diagnostic Group’s customer service department at [phone].
Once you have installed the software on the server and client computers, you must
configure the software for virtual channel operation as described in the “Configuring the
IQmark Diagnostic Workstation” section of the IQmark Diagnostic Workstation
Operation Manual and in section II-D Configuring the Spirometer in this manual.
Next
Back
Go To Table Of Contents