Specifications

IQmark Digital ECG Operation Manual

Configuring for Serial-Type ECG Module

If you have a serial-type ECG module, you can select the serial port for the ECG module

in the configuration screen. Click Serial Port to open the following dialog box:

 NOTE: The default serial communications port is COM 1.

Click Auto Detect to find the port that the ECG module is connected to; the ECG module

must be connected to an available serial port on the computer. Confirm that a fresh set

of batteries is installed in the ECG module and click Auto Detect for ECG COM ports. The

result appears on the screen. Some ECG modules may need to be turned on manually

for Auto Detect to work; press the switch to turn on the module.

Configuring for USB-Type ECG Module

If you received a USB-type ECG module and it is already connected to the computer, the

ECG COM Port setting will be disabled once it is detected.

Thin Client Channel Setting

The Thin Client Channel setting applies only if you are using IQmark Diagnostic

Workstation in a thin client environment. This setting is ignored when the software is

not running in a thin client environment. The drop-down list contains the following

selections:

COM port mapping (default)

Microsoft RDP

Citrix

Select COM port mapping if you are using IQmark Diagnostic Workstation in a thin client

environment and are not using IQpath. If you are using IQpath, select Microsoft RDP or

Citrix, depending on what your clients and servers are using. Please refer to the Setup

Manual: IQpath Thin Client Virtual Channel Software for more information.

Go To Table Of Contents