Specifications

IQmark Digital ECG Operation Manual

display area. Place the mouse pointer on the blank portion of the Taskbar on the bottom

of the screen, then right-click and select Properties. Check the Auto-hide the taskbar

box to hide the taskbar when it is not in use; to display the taskbar when it is hidden,

move your mouse cursor over the area where your taskbar is normally set, and it will

reappear.

Screen Saver

If a screen saver or any energy saving feature is enabled on the computer, make sure

that it does not activate and interfere with data acquisition during patient care. Refer to

your computer or software manual for these settings.

Installation Steps for IQmark Diagnostic Workstation

 NOTE: Close all Windows programs before installing this software. Do not interrupt

the installation program while it is running. The installation should take less

than five minutes.

1. Insert the IQmark Diagnostic Workstation Installation CD into the CD-ROM or DVD-

ROM drive. The installation starts automatically. If the installation does not start

automatically, double-click My Computer on the desktop and double-click the CD-

ROM icon to start.

2. Follow the instructions on the screen. For detailed installation, setup and detailed

operation instructions, please refer to the IQmark Diagnostic Workstation Operation

Manual.

D. Connecting the IQmark Digital ECG Module

Serial-Type ECG module

If you have a serial-type ECG module, attach the female end of the 9-pin communication

cable to any available serial port on the PC. If you are using a USB port with the serial-

type ECG module, install the USB to serial port adapter before you connect the ECG

module to the Adapter. Secure the connections with the thumbscrews. Do not over-

tighten.

 NOTE: Almost all USB to serial port adapters come with specific software drivers

that must be installed prior to use. Before connecting the ECG module to any

adapter, ensure that all software drivers have been installed according to the

manufacturer’s instructions.

USB-Type ECG module

If you received a USB-type ECG module, you can connect it to any available USB port on

the computer after IQmark Diagnostic Workstation is installed. As with other USB

devices, Windows will attempt to identify the ECG module the first time it connects to it.

This may take a few seconds.

Go To Table Of Contents