Specifications

IQmark Digital ECG Operation Manual

2. For the serial-type ECG module, slide out and remove the battery door

underneath the module and install 2 AA batteries. Be sure to follow the

battery positions indicated. Replace the battery compartment door.

For the USB-type ECG module, no batteries are required.

3. Attach the patient cable to the 15-pin connector on the ECG acquisition module.

Figure 2.0 IQmark Digital ECG Acquisition Module.

C. Software Installation

 NOTE: The following software installation information refers to IQmark Workstation

only. If you are using your IQmark Digital ECG through an EMR, please

contact Midmark Support Services for assistance with installation and setup.

The medical diagnostic application, IQmark Digital ECG, uses IQmark Diagnostic

Workstation to manage patient records. When you install or upgrade the IQmark Digital

ECG, IQmark Workstation is automatically installed or upgraded accordingly (see IQmark

Diagnostic Workstation Operation Manual for further information).

You can also access other Midmark products, such as the IQmark Digital Holter, IQmark

Digital Spirometer, Digital Stress, Vital Signs Interface and Weight/Scale Interface from

IQmark Diagnostic Workstation. Call Midmark Sales Department for the latest

information on available Midmark products.

 NOTE: If you already have IQmark Diagnostic Workstation installed on your

computer and you are now either upgrading or adding a new Midmark

product, please skip this section and refer to the IQmark Diagnostic

Workstation Operation Manual for installation information.

Before installing IQmark Diagnostic Workstation on your computer, it is important that

you understand and carry out the following tasks:

Windows Taskbar

IQmark Diagnostic Workstation is designed to run as a full-screen program. For best

results, the Windows Taskbar should not be displayed in order to provide maximum

Patient Cable Connection

Go To Table Of Contents