Specifications

IQmark Digital ECG Operation Manual
4
IQpath for Citrix ICA if you are using Citrix software on your clients and servers.
These software products are provided separately and may be obtained by contacting
Midmark at (800) MIDMARK (643-6275).
Once you have installed the software on the server and client computers, you must
configure the software for virtual channel operation as described in Section II-D
Connecting the IQmark Digital ECG Module and Section II-E Configuring the IQmark
Digital ECG.
Thin Client Using COM Port Mapping
COM port mapping refers to a configuration in which the ECG device connects to a serial
port of the client and the server is configured so that logical COM ports on the terminal
server are mapped to the physical COM ports of the client.
If you are using non-Windows-based thin client terminal devices on a low-latency, high-
speed network you must use the serial port versions of the ECG device and configure
the thin client server for COM port mapping.
 NOTE: In order to use the COM port mapping solution in a thin client environment,
the computer hardware and software as well as the network must meet
stringent performance requirements. System administrators must read the
document Setup Manual: Midmark Products over Thin Client Environments
before installing, configuring and using this software in a thin client
environment using COM port mapping.
The following block diagram illustrates the use of the ECG device in a thin client
environment using COM port mapping:
Go To Table Of Contents