Specifications

IQmark Digital ECG Operation Manual
3
high-speed networks, use the serial port versions of the IQmark Digital ECG and connect
to client devices via COM port mapping.
Setting up any application in a network environment typically requires special access
rights and knowledge of the network. Please have your system administrator install and
configure the IQmark Diagnostic Workstation to your office environment.
Thin Client Using the IQpath Virtual Channel Solution
IQpath provides the following advantages over COM port mapping:
Improved performance on high-latency, low-bandwidth, high-loss networks.
o Microsoft Terminal Services: Improvement is approximately 10-to-1 in
latency tolerance.
o Citrix ICA: Improvement is approximately 40-to-1 in latency tolerance.
No COM port mapping is required.
The USB version of the ECG module is compatible.
Improved device auto-configuration and diagnostics.
NOTE: IQpath has specific requirements for computer hardware, software and
network performance. System administrators should read Setup Manual:
IQpath Thin Client Virtual Channel Software before installing, configuring and
using this software in a thin client environment.
The following block diagram describes IQpath. In this thin client environment, the client
computers must be running Windows XP SP2 or Windows Vista:
To use IQpath, load IQmark Workstation on the terminal server and install one of the
following software components on each client PC that you intend to use for data
acquisition:
IQpath for Microsoft Terminal Services if you are using Microsoft Terminal
Services (Microsoft RDP).
Go To Table Of Contents