User`s manual

CARDELL

Veterinary Monitors

21-02-0285 REV. 06 07/11

For the Auto “OFF” feature to work properly, the following conditions must apply;

 Alrm Off is selected in the Configuration Menu.

 The CARDELL Monitor is operating on battery power.

 No NIBP or SpO

readings were taken in the past ten (10) minutes.

 No key presses were made in the past ten (10) minutes.

 The monitor cannot be in the Automatic NIBP cycle mode.

POWER FAIL

The CARDELL Monitor incorporates a Power Fail feature. Whenever the power is disconnected

from the monitor and the monitor is not allowed to shut down in an orderly fashion, the monitor,

when re-powered alerts the user. The message “Pwr Fail” is displayed in the Message Window

and three (3) audio “beeps” followed by two (2) audio “beeps” are heard every ten (10) seconds.

During this condition, all other pushbuttons are inactive except for the POWER and

SILENCE/RESET.

To clear the Power Fail condition, and return to “Ready”, press the SILENCE/RESET pushbutton

or properly recycle the monitor’s power.

USER MESSAGES

The CARDELL Monitor displays a variety of messages to aid the user in monitor operation. If a

troubleshooting message is displayed during a measurement, follow the actions listed to correct

the situation.

If the monitor does not turn on, or exhibits a flashing display and failure to operate, the battery is

most likely below the Dead Battery point. Connect the monitor to an AC wall outlet and allow it

to charge for four (4) hours.

Refer to Table 7, Error Messages on the Message Window for more information.

If the monitor is in need of repair, it must be referred to the appropriate service personnel.

Service performed by unauthorized personnel could be detrimental to the monitor and will void

the warranty. For service, contact CAS Medical Systems, Inc.

Back

Go To Table Of Contents