User`s manual

CARDELL

Veterinary Monitors

21-02-0285 REV. 06 07/11

MAP VALUE ENABLE / DISABLE

During a blood pressure reading, the user can elect to display or not to display the MAP value.

Should it need to be changed, first enter the Configuration menu. Refer to Page 67, ENTERING

THE CONFIGURATION MENU. Once in the menu, use one of the NEXT programmed

pushbutton keys until the Message Window displays the monitor’s current setting for the MAP

value “MAP On” or “MAP Off”.

Use the ARROW UP or ARROW DOWN pushbuttons to make your selection.

NOTE:

When “MAP Off” is selected, MAP values are omitted from History Display and Printing as well.

All alarms associated with MAP values are also disabled.

Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the

CANCEL pushbutton to exit to the “Ready” mode.

SET THE SpO

ALARM DELAY

The delay time until an alarm is generated for %SpO

and Pulse Rate can be configured to be

either zero (0) seconds “Delay 0S” or ten (10) seconds “Delay10S”. The default value used by

the CARDELL Monitor is ten (10) seconds.

Use the ARROW UP or ARROW DOWN pushbuttons to make your selection.

Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the

CANCEL pushbutton to exit to the “Ready” mode.

SETTING THE DATE

The CARDELL Monitor’s Date value is set at the factory. Should it need to be changed, enter

the Monitor Configuration menu and use one of the NEXT programmed pushbutton keys until

the Message Window displays the monitor’s date using the following format: “DDMMMYY”.

Where DD = Day of the Month, MMM = Month of the Year (Jan, Feb, etc.) and YY = Last 2 digits

of the year (2002 is displayed as 02). The flashing parameter indicates the parameter that can

be changed.

Use the ARROW UP or ARROW DOWN pushbuttons to make your selection. Press one of the

NEXT programmed pushbutton keys to advance to the next parameter to set within the Date

menu.

Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the

CANCEL pushbutton to exit to the “Ready” mode.

Back

Go To Table Of Contents