User`s manual

CARDELL
®
Veterinary Monitors
21-02-0285 REV. 06 07/11
64
EQUIPMENT ALARMS
During an Equipment Alarm, the monitor displays the alarm parameter in either the Message
Window or flashes the LED display of the alarmed parameter and provides an audible Alarm
Tone. To clear the alarm, press the SILENCE/RESET pushbutton. The monitor silences the
audible tone and clears the parameter.
NOTE:
The Low Battery and Dead Battery alarms cannot be silenced.
ADJUSTING THE AUDIO ALARM VOLUME
The Alarm Volume can be adjusted to one (1) of five (5) volume levels. Press the AUDIO
pushbutton. The Message Window displays the current value of the Audio Alarm Volume
“ALARM
”.
Use the ARROW UP and ARROW DOWN pushbuttons to adjust the volume level desired.
Altering the Alarm Volume will produce a single tone at the selected volume level.
Press the CANCEL pushbutton when completed.
NOTE:
The Volume Level cannot be set to “OFF”.
NOTE:
No “Key Click” will be heard when the Audio Volume is set to a MINIMUM setting.
ADJUSTING THE SpO
2
“BEEP” VOLUME
(Model 9402 only)
The Volume for the SpO
2
“Beep” can be adjusted to one (1) of five (5) levels and “OFF”. This
setup menu follows directly after the Audio Alarm Volume. Press the AUDIO pushbutton until
the Message Window displays the SpO
2
Volume message “SpO2 ”.
Use the ARROW UP and ARROW DOWN pushbuttons to adjust the volume level desired.
Altering the SpO
2
Volume will produce a single tone at a selected “non-off” volume level.
Press the CANCEL pushbutton when completed.
Next
Back
Go To Table Of Contents