User`s manual

CARDELL

Veterinary Monitors

21-02-0285 REV. 06 07/11

NOTE:

If the printer was powered “ON” during the monitor’s power-up sequence, the Midmark logo is

printed.

Once the Power On Self-Test is completed, the monitor indicates that it is “Ready” for use.

FRONT PANEL INTENSITY CONTROL

The CARDELL Monitor utilizes Super Bright LED displays in its front panel for better viewing in a

variety of environments. If the displays are too bright or should the need come to operate the

monitor in a dimly lit environment, the monitor incorporates a user selectable Intensity Control.

Press and hold the front panel AUDIO pushbutton for two (2) seconds. The monitor’s front panel

LED displays will toggle from their bright to their dim intensity level.

Continue to press the AUDIO pushbutton and every two (2) seconds the monitor’s front panel

LED displays will toggle; dim to bright, bright to dim. Release the AUDIO pushbutton and select

the intensity level required. The CARDELL Monitor remembers this setting and will power-up the

next time to the intensity level selected.

DISPLAYING THE TIME

The CARDELL Monitor can be used to display the current Time of day (as set by the user) at

any time. Press and Hold the CYCLE TIME pushbutton for two (2) seconds.

The monitor displays the Time, in 24 Hr. format in the Message Window for as long as the

pushbutton is pressed.

LARGE CUFF / SMALL CUFF OPERATING MODES

NIBP function is affected by changing between LARGE CUFF and SMALL CUFF operating

modes. Once the monitor’s power is on, a visual indicator, located on the front panel of the

monitor, indicates the current operating mode.

Press and Hold the CANCEL pushbutton for two (2) seconds to change the operating mode.

IMPORTANT:

Prior to patient monitoring, ensure the monitor is configured to the appropriate patient mode –

Large Cuff or Small Cuff. The factory default is SMALL CUFF mode.

Back

Go To Table Of Contents