User`s manual

CARDELL

Veterinary Monitors

21-02-0285 REV. 06 07/11

CUFF PLACEMENT FOR A DOG

For measurements in dogs, it is preferable to use the right lateral, sternal or dorsal recumbent

positions. That is not a problem in anesthetized patients, but it may be difficult to get large dogs

to cooperate for proper positioning. If the dog is in a sitting position, place the front paw on the

operator’s knee and take measurements from the metacarpus.

Sites for cuff placement are the metacarpus, metatarsus and anterior tibial. In anesthetized

patients, most surgeries are done on the posterior part of the body so the metacarpal area of the

forelimb is most convenient. In situations where this is not possible, the cuff should be wrapped

around the metatarsus just proximal to the tarsal pad or around the hind leg just distal to the

hock. The tail site should not be used for cuff placement during anesthesia.

If the hair over the artery site is too thick or matted for good contact, it should be clipped.

Figure 3: Dog Cuff Placement

NOTE:

Use metacarpus or metatarsus.

To achieve the most accurate readings, it is important to keep the cuff on a horizontal plane with

the heart.

Back

Go To Table Of Contents