Service manual

CARDELL MONITOR SERVICE MANUAL
21-02-0286 REV. 02 05/09
85
Installation
1) Install the RS232 Interface Board into the Module case and secure it with the three (3)
screws previously removed.
2) Re-install the module and secure it to the monitor’s rear case using the Loctite adhesive
and the one (1) screw previously removed. Apply a small amount of the adhesive to the
threads of the screw and torque to 32 in.-oz.
3) Perform a complete System Check as described in the section MAINTENANCE
PROCEDURES.
Back
Next
Go To Table Of Contents