Manualshelf

Service manual

ManualsBrandsMidmark ManualsBlood Pressure MonitorCARDELL 9401
71727374757677787980
CARDELL MONITOR SERVICE MANUAL
21-02-0286 REV. 02 05/09
79
REPLACING THE POWER SUPPLY MODULE
The Power Supply Module is part of the Rear Case Assembly.
Removal
1) Complete the steps in Prior to Disassembly and Monitor Disassembly.
2) Disconnect the two (2) harness assemblies from the Power Supply Module.
3) Remove the four (4) screws that secure the module to the rear case.
4) Remove the defective Power Supply Module.
Figure 12: Replacing the Power Supply Module
Installation
1) Install the Power Supply module into the rear case so that the connectors on the Power
Supply Module are at the bottom of the monitor’s rear case.
2) Secure the Power Supply module using the hardware previously removed.
3) Re-connect the wire harness from the AC input receptacle.
4) Re-connect the wire harness that will be connected to the J1 connector on the Main
Control Board.
5) Finish assembling the monitor by following the steps in section Monitor Assembly.
Back
Next
Go To Table Of Contents