Service manual

CARDELL MONITOR SERVICE MANUAL
21-02-0286 REV. 02 05/09
65
DISPLAYING THE TIME
Perform the following procedure to verify the time is set correctly.
Press and hold the CYCLE TIME pushbutton for two (2) seconds.
The monitor displays the time, in 24 Hr. format in the Message Window for as long as the
pushbutton is pressed.
Should the time being displayed not be correct, refer to Section SETTING THE TIME.
ALARM AUDIO
Perform the following procedure to verify the audio range for the Alarm volume.
Press the VOLUME pushbutton on the front panel. Verify a Key Click tone is heard and the
Message Window displays “ALARM
”.
Press the VOLUME UP and VOLUME DOWN pushbuttons and verify the Alarm Volume can be
adjusted to one of five volume levels.
Set the volume level as desired.
Press the CANCEL pushbutton when completed.
NOTE:
The Alarm Volume level cannot be set to “OFF”.
NOTE:
No Key Click will be heard when the Audio Alarm Volume is set to a MINIMUM setting.
Back
Next
Go To Table Of Contents