Service manual

CARDELL MONITOR SERVICE MANUAL
21-02-0286 REV. 02 05/09
40
SOFTWARE REVISIONS
The CARDELL Monitor displays the current software revision of its operating system and that of
the internal modules being used inside. The software versions are displayed in the following
order:
Software Module Message Window
CARDELL Control Board VER X.X
Boot Loader BootX.XX
Power Supply PIC Processor PIC X.X
CAS NIBP Module ND X.X
Nellcor SpO
2
Module
(1)
Nonin SpO
2
Module
NEL X.X
NON XX
Table 3: Software Revisions
Use the ARROW UP or ARROW DOWN pushbuttons to view the messages.
Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the
CANCEL pushbutton to Save your changes and exit to the “Ready” mode.
SETTING THE LANGUAGE
The CARDELL Monitor can operate in one (1) of nine (9) languages: English, German, French,
Italian, Spanish, Dutch, Swedish, Portuguese or Norwegian.
To configure the monitor’s operating language, first enter the Monitor Configuration menu.
Refer to Page 39, ENTERING THE MONITOR CONFIGURATION MENU.
Once in the menu, use one of the NEXT programmed pushbutton keys until the Message
Window displays the current language being used.
Use the ARROW UP or ARROW DOWN pushbuttons to make your selection.
Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the
CANCEL pushbutton to exit to the “Ready” mode.
(1) Available SpO
2
Oximetry is either Nellcor or Nonin. In the Model 9401 monitor, this
message is skipped.
Back
Next
Go To Table Of Contents