User's Manual

Specifications
Range of Operation ............. 20 ft. (6 m) radius
Batteries:
Hand Control .................................AA (qty. 2)
Foot Control ..................................AA (qty. 2)
Troubleshooting
When any control button is pressed, that controller
sounds a single “beep”. (All functions operate)
Cause: Low battery
Solution: Replace batteries
When any control button is pressed,
nothing happens. (No “beeps”, no movement, etc.)
Cause: 1. Batteries completely dead
2. Wireless controller has lost
“association” to chair
Solution: 1. Replace batteries
2. Perform Association Procedure*
The wireless controllers will only function with the ...
chair they have been “associated” with. This prevents
unwanted movement in locations with more than one
chair.
If further service is required,
contact your authorized Midmark dealer.
Association Procedure
The wireless controller will only function with the chair it has been “associated” with.
This prevents unwanted movement in locations with more than one chair.
Each wireless controller’s association is preset at the factory. This procedure is only
required in the event of a malfunction, if a new controller is purchased, or if you are
attempting to use the controller with a chair other than the one it was originally
associated with.
Association Procedure:
A) Disconnect power to the table for at least 3 seconds.
B*) Reconnect power, then press & hold the Stop & Home buttons
on the wireless controller, until you hear three “beeps”.
* Note: Step B must be performed within 10 seconds of Step A.
C) Check for proper operation of wireless controller.
D) If associating a hand and foot control, repeat procedure using
the other wireless controller.
Stop
Home
MA771100i
Stop