Installation Guide

Step 4: Set-up Scaler...

A) Make sure Midmark power switch is OFF.

B) Screw scaler tip on and tighten moderately with tool provided.

C) Plug handpiece into hose connection, place in designated handpiece holder.

D) Turn Midmark ON.

E) Set scaler intensity knob to lowest position in the color range that corresponds to the tip color.

F) Remove from holder, depress foot pedal and adjust the water control knob until a steady FINE mist is produced.

G) Scaler is ready to operate.

English - 3

Equipment Alert

The Satelec scaler accessory is manufactured by ACTEON North America. Refer to ACTEON’s

literature for detailed information on operation and maintenance. For additional information go to: www.acteonsupport.com.

003-1878-99