Installation Guide
© 2020 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1.800.643.6275 | 1.937.526.3662 | www.midmark.com
English - 2
Step 2: Locate cart in area of operation.
Place foot control on floor.
Remove, fill with distilled water
and replace water bottles.
Step 3: Connect power cord to cart.
Plug cord into appropriate wall outlet.
On/Off switch is located on unit
above power cord plug.
Note: Perform checks on next page before operating
instruments.
Needle
Valve
CartOn/O
Power Switch
To
Close
Step 1: Close water needle valve for
handpieces that do not use water,
like most low-speed handpieces and
polishers.
High Speed
Low Speed
Syringe
Scaler
003-1878-99