Owner's manual

midlandusa.com
Midland BTX1FM - Page 8
6� Follow the pairing procedure of your GPS� If a pin code is requested you must enter
“0000” (four zeros)�
7� When successfully paired, the Blue LED light of the unit will be on for one second
and then the unit will exit setup mode and switch to the working mode (the Blue
LED light will start ashing)�
When you pair the GPS to the “Volume +” button, you lose the ability to pair a phone
to the BTX1FM unit� You can overcome this limit by pairing the phone directly to the
GPS and then the GPS to the BTX1FM unit� All phone features are then managed by
the GPS unit�
GPS navigator always in the background
To keep the intercom open while the GPS gives turn by turn directions you must have
the “background” feature active�
Attention: Midland cannot guarantee this feature because it depends on a third party
device.
Listening to FM Radio
The FM Radio receiver is integrated� Switch to the “FM Radio” mode in order to use it�
Long press (3 seconds) the “Middle” button until you hear “FM Radio” from the voice
announcement� Now all three main buttons are dedicated to the FM Radio (See Table
C)�
Tap the “Forward” or “Back” button to seek the FM Radio station� When you long press
(3 seconds) the “Forward” or the “Back” button, you can scan up or down between 6
recorded stations� A voice announcement will tell you the memory slot number you
are entering� A double beep tone will sound when the rst or last recorded station
is reached�
To save the station you are listening to, press the “Forward” and “Back” buttons to-
gether for 3 seconds� You will hear a beep tone for conrmation�
The station is saved over the last recorded station used�
Using the RDS system, the BTX1FM will stop on the strongest signals available� RDS is
a standard for embedding digital information in FM Radio broadcasts�
The RDS system is OFF by default� If needed, you can toggle the RDS on/o by pressing
the “Volume +” and “Volume -” buttons together for 3 seconds when the radio is on� A
voice announcement will tell you the RDS status�
Table C - FM Radio mode
Mode Forward button Middle button Back button
FM Radio Tap: Seek station up
Long press (3 seconds): Station recorded
Tap: On/o
Long press (3 seconds): Change mode
Tap: Seek station down
Long press (3 seconds): Station recorded
FM Radio with intercom
When you are in “FM Radio” mode you can only open the intercom using the VOX fea-
ture to the unit paired on the “Middle” button� To manually activate the intercom you
must switch to “Intercom” mode�
Disabling/Enabling the FM Radio
By default the FM radio is on�
Disabling:
› Enter setup mode: Turn o the unit and hold down the “Middle” button for 7 sec-
onds until the Red LED light is on permanently�
› Press the “Middle” and “Volume +” buttons together for 3 seconds� The Blue LED
light will ash twice�
› Double press the “Middle” button to exit setup mode and the BTX1FM is ready to
use�
Enabling:
› Follow the same procedure described above� The Blue LED light will ash once�
› To exit setup mode, double press the “Middle” button�
Pairing to a GMRS radio with integrated or external Bluetooth
If your GMRS transceiver has integrated Bluetooth, pair the transceiver using the
“Volume +” button:
› Turn o the unit�
› Press and hold down the “Middle” about 7 seconds, until the Red LED light is on
permanently�
› Now press the “Volume +” button for 3 seconds� The Blue and Red LED lights will
ash�
› Follow the pairing procedure explained in the manual of the transceiver�
Attention: The GMRS audio connection can be set to “Stand by” by pushing the “For-
ward” button on the BTX1FM in “Phone” mode.