Owner's manual

midlandusa.com
Midland BTX1FM - Page 7
Making a call in Phone mode only
There are several ways to make a call�
From the phone keypad:
Dial the number on the phone keypad:
Press “Send” on the phone�
To redial the last number:
Press the “Forward” button for 3 seconds in order to redial the last number (you will
hear an audible conrmation tone)�
To make a voice call:
Briey press the “Forward” button� If your phone supports voice calls, you will be
asked to speak the name of the contact you want to call�
Priority: Calls have the highest priority, which means that all other communications are
temporarily disabled when a call is received and automatically re-enabled once the call
ends.
B-Phone mode
Mode Forward button Middle button Back button
Phone Tap: Voice dial /accept or close if it is
in progress
Long press (3 seconds): Redial last number/
or reject incoming call
Long press (3 seconds): Change mode Long press (3 seconds): Toggle on/o wired
Phone (when music is
playing)
Tap: Next song Tap: Play/pause
Long press (3 seconds): Change mode
Tap: Previous song
Ending a call in both Phone and Intercom mode
There are several ways to end a call:
› Wait for the person you called to hang-up�
› Press the “Forward” button (you will hear an audible conrmation tone)�
› Press the “End Call” button on the phone�
Using the MP3 player feature of the phone in Phone mode only
Many phones are now designed to be used as stereo MP3 players� The
BTX1FM fully supports the A2DP and AVRCP protocols that enable you to
listen to stereo music and remotely control your mobile phone’s MP3 player� You
can even use the buttons on the BTX1FM to control the following play options:
Play, Pause, Forward and Back�
Play/Pause
Forward Back
Available controls
› To play/pause music: Press the “Middle” button�
› To skip forward to the next song: Press the “Forward” button�
› To skip back to the previous song: Press the “Back” button��
Priority: The music listening mode has the lowest priority. It will always be disabled
when another type of communication is enabled.
Pairing to a GPS navigator
The GPS Navigator can be paired to the “Volume +“ button� When paired the
“phone mode” is active�
Attention: If you need to connect both a phone and GPS, you must pair the phone to
the GPS itself.
Pairing the BTX1FM to a GPS
First enter setup mode:
1� Turn o the unit�
2� Press and hold down the “Middle” button for 7 seconds until the Red LED light is
on permanently�
3� Press the “Volume +” button for 3 seconds� The Blue and Red LED lights will ash�
4� Enable the Bluetooth device search feature on your GPS�
5� After a few seconds, “Midland BTX1FM” will be displayed on your GPS�