Owner's manual

midlandusa.com
Midland BTX1FM - Page 2
MIDLAND BTX1FM
Basic intercom system
The BTX1FM is an intercom communication system for motorcyclists. The design is slim and aerodynamic, and all main functions are easy to operate with the three big buttons.
The BTX1FM is xed to the helmet using either the adhesive plate or the screw mounting clamp. With an audio kit and ultra slim speakers, you can enjoy high quality stereo music
while riding.
Main features
› Intercom driver to passenger up to 30 ft� range
› FM Radio with Stereo audio and RDS (Radio Data System)
› Connect your phone to receive or place phone calls and listen to music
› Connect your GPS for turn by turn directions
› Connection for GMRS radios with internal or external Bluetooth
› AUX wired connection for MP3 players and GMRS radios
› Setup and Firmware update via USB connection to a PC
Midland BTX1FM is available in two versions:
› Single BTX1FM Intercom kit with one unit only
› Twin BTX1FM Intercom kit with two units
Depending on the model purchased, the package contains the following
parts:
BTX1FM Single
› 1 BTX1FM communication unit
› 1 audio kit : Two stereo speakers with boom and wired microphones
› 1 plate with bi-adhesive strip
› 1 helmet clamp
› 1 mini USB wall-mounting power supply
BTX1FM Twin
› 2 BTX1FM communication units
› 2 audio kits: Two stereo speakers with boom and wired microphones
› 2 plates with bi-adhesive strip
› 2 helmet clamps
› 1 mini USB wall-mounting power supply with double plug
The units included in the TWIN kit are already paired and can therefore be immediately
used in Intercom mode.
Technical specifications of Midland BTX1FM
General:
› Bluetooth ver. 3.0 stereo (Headset/Handsfree/A2DP protocol)
› AGC system automatically controls the volume in relation to background noise
› Voice (VOX) or manual communication activation
› Manual controls to enable telephone, intercom and wired connection
› Fully waterproof
› Lithium battery with up to 12 hours talk time
› Recharge time is approximately 6 hours
Bluetooth connections:
Bluetooth devices:
› Cell phone with MP3 player Stereo (A2DP protocol), GPS (Garmin Zumo and
TomTom Rider 1 and 2)
› GMRS transceivers (with built-in or external Bluetooth connection) for group
bike-to-bike communications
Wired connections:
› Stereo audio input for iPod/MP3 player (with optional cable)
› GMRS transceivers (with optional cable)
Attention: Midland BTX1FM is designed to withstand rain and water. Always verify
that the rubber caps protecting the sockets are fully tted.
With identical device for Driver to Passenger intercom�
Charging batteries
Attention: Make sure the unit is fully charged before use. Allow at least 8 hours for a
full charge before using the unit for the rst time.
Charge the unit by inserting the wall charger into the charging socket (lift the rub-
ber cover to insert the plug)�
The red LED on the unit will start ashing when charging begins�
Allow the headset to charge until the unit stops ashing or the blue LED turns on�
When the charge is complete (the red LED is not ashing), release the headset from
the charger�