User Manual

Model BR200
midlandusa.comPage 10
INSTALLING THE ANTENNA
Align the antenna with the threaded
connector located on the top of the
radio. Holding the antenna at the
base, rotate the antenna clockwise
until secure.
*Be careful not to over tighten to
avoid damaging antenna mount.*
INSTALLING EXTERNAL
ACCESSORIES
Pulling the rubber cover to the side
exposing the speaker/mic jacks, insert
the accessory plugs into the speaker/
mic jack.
CHARGING THE BATTERY PACK
Your radio is equipped for using a rechargeable Lithium-Ion battery pack
which can be recharged by inserting the radio or battery into the desktop
charger (as described below). Midland recommends charging the battery
pack when the charge battery alert comes on and removing the radio from
the charger when the charging is finished.
To charge using the Desktop Charger:
1. Plug the AC adaptor into a 120V AC wall outlet. The charger’s LED
turns green when power is present.
2. Making sure the battery contacts and charge terminals are clean and
in good condition, slide the battery or radio with installed battery into
the charger.