® 40 KAN 40 CAN ÄLE AM/FM ALI AM /FM ALAN 4 8 EXCE 40 AM /F 40 CAN M - CHANNEL S 40 CAN ALES AM/FM AUX AM /FM L MANUALE ISTRUZIONI - USER'S MANUAL MANUEL D'UTILISATION - MANUAL DEL USUARIO ALAN 48 EXCEL
INDEX Introduction............................................................................................ 2 Function and location of the controls..................................................... 3 Installation............................................................................................. 7 Power supply...................................................................................... 7 Installing an antenna..........................................................................
ALAN 48 EXCEL MULTI is a mobile transceiver whose main feature is the possibility to select any of the European CB bands with an easy and quick operation. ALAN 48 EXCEL MULTI is equipped with the “ESP2” (noise reducer device) that reduces considerably the audio noises up to 95%, allowing a clear communication even when the signal is disturbed. The wide multifunctional backlit display shows the number of the channel in use or the correspondent frequency even in conditions of deep darkness.
FUNCTION AND LOCATION OF THE CONTROLS FRONT PANEL 7 3 6 5 4 VOL CH 01 0 3 2 17 18 5 7 9 30 3 5 10 POWER EMG F MIC CB/PA FUNC 2 8 SQ TX RX AM M1 EMG 9 LOW ESP LOCK DW SCAN MIC RF FM M2 DW M3 SCAN 10 M4/LCR AM/FM M5 LOCK N.K. 12 13 14 11 16 15 1. Channel selector: it permits the manual channel selection. 2. Microphone jack: insert the mic connector into this jack. 3. Indicator: this meter indicates the receiving signal strength and the transmitter RF output power. 4.
. “AM/FM” Indicator It indicates the operative mode. FM: red LED; AM: green LED. 6. “RX/TX” Indicator LED indicating receiving or trasmitting mode. RX: green LED; TX: red LED. 7. “CB/PA” Selector In the “CB” position, the unit operates as a transceiver. You can use the PA (public address) function only if you connect a speaker to the PA jack (“PA” visualized on the display). In this case the “MIC” knob controls the amplification level. 8.
E N G L I S H memory and “SCAN” function activation. In this case, you can automatically seek for a busy channel: • turn the squelch clockwise until the background noise is no longer heard; • press the “M3 - SCAN” button: “SCAN” will be shown on the display and the transceiver will automatically scan all the channels until a carrier is being received. This function can be deactivated in three ways: pressing the PTT button, turning the channel selector or simply pushing any other button on the unit. 12.
REAR PANEL 19 20 21 22 S-METER PA EXT ANTENNA 23 19. Antenna connector (SO239 connector type). 20. S.Meter jack: it allows an external “s meter” connection. 21. “PA” jack: by connecting with an external loudspeaker, you can use the unit as an audio-amplifier. 22. ”EXT” jack: external loudspeaker jack (the internal loudspeaker is excluded). 23. Power 13.2 Vdc: power supply cable. MICROPHONE UP 1 1. PTT: transmission button 2. UP/DOWN buttons: manual channels selector. 3.
INSTALLATION Safety and convenience are the primary consideration for mounting any piece of mobile equipment. All controls must be readily available to the operator without interfering with the movements necessary for safe operation of the vehicle. Set the proper position in the car to install the transceiver using the supplied supporting bracket or eventually the slide bracket. Tighten the retaining screws. The fixing bracket must be close to metallic parts. POWER SUPPLY Be sure the transceiver is off.
HOW TO OPERATE WITH YOUR ALAN 48 EXCEL MULTI 1. 2. 3. 4. 5. 6. 7. Screw the microphone plug into the microphone jack. Make sure your antenna is securely connected to the antenna connector. Make sure the SQUELCH control is turned fully conterclockwise. Turn on the unit and adjust the volume control. Select your desired channel through the “UP/DN” buttons on the microphone. To transmit, press the PTT button and speak with a normal tone of voice. To receive, release the PTT button.
SPECIFICATIONS GENERAL Channels .......................................................... 40 FM (see the Frequency band chart) Frequency Range . ...........................................................................25.615-30.105 MHz Frequency Control . ...................................................................................................PLL Operating Temperature Range......................................................................-10°/+55° C DC input voltage . .....................
