User manual

The „MP11 Utility“ icon has been added to desktop during the software ins-

tallation, so you can double-click this icon from now on to run the program.

After this double-click, the main window of MP11 Utility will be displayed. In

this window, you must rst add the songs that you are preparing for MP11

and want to copy on to the storage medium.

Therefore, in the main window click the button „Selection of songs intended

for MP11 storage“.

This launches another window. In this window, rst select the folder in which

your les are located. Select the le or les that you want by mouse-click

(you can select several les if you hold down the control key) and then click

„Open“.

Another important note regarding the le selection mentioned above: if you

work with MIDI as well as MP3 les, make sure during every MP11 Utility session

you choose only one le-type when selecting les (either MIDI les OR MP3 les);

due to the following reason: Later, when you move les to the MP11 storage

medium, you should copy the MIDI les in one folder (e.g. a folder called „midi“)

and the MP3 les in a separate folder (e.g. a folder called „MP3“). These folders

are already on the CompactFlash card that is included in delivery. This will help

you copy les always on to the proper folder when you later move les to the

MP11 storage medium.

Let‘s get back to the next steps: After selecting your les and clicking the

„Open“ button, the les will be listed in a table.

And, as pointed out already in Section -> MP11 UTILITY -> INTRODUCTION,

you should add as much song information as possible to these les, so that

you can use the full potential of MP11.

If you are using © M-Live les, it will take you only a few steps to add song

information to your les. Simply click the button „Synchronize songs with

M-Live database“. This opens the additional Backup window that allows you

to decide if you not only want to synchronize the songs, but also make an

additional backup, or if you want to continue without a backup.

With backup: Click the „Find“ button in the displayed Backup window. This

opens a new window, where you can select the folder (or create a new fol-

der), in which the backup le should be stored. Once you have selected the

folder of your choice, click the OK button (-> this closes the folder-selection

window). Now, in the Backup window, you can click the button, „Backup“.

This creates the backup, and synchronizes with the M-Live database at the

same time - in addition, all the song information is automatically added to

the les.

les that were created after August 2010, because these les already contain all

you can resort to the abovementioned function to integrate the song informati-

on.

MP11-Utility: Handling