Owner`s manual

....

Module Player

This screen contains several areas, which will be described below.

1 Song Position Allows you to set the desired measure position within a song by measure,

beat and MIDI ticks. The set measure position is activated by pressing

ENTER/YES on

the control panel of the remote controller. This may also be done while playing the song;

however, this might not be very practical, because it is very difficult to make a smooth

change of songs while a song is playing. Therefore, use this function to set a position from

where you want to start the song.

2 Edit Song This button recalls the [MIDI file edit] screen, allowing you to edit a MIDI file

extensively. Please refer to chapter 9.25 - [Edit file] button in the [MediaProp] Screen -

on page 91 for more information.

3 The Loop button on the upper right enables the loop. A loop means that

specific (freely selectable) time frames will be repeated continuously,

according to the loop’s setting.

4 Song Tempo This area allows you to modify the current song tempo. Use the data wheel

or the keypad to perform the change. Afterwards press the

ENTER/YES key. The

selection provides the following options:

• Absolute Changes the current song tempo to the exact value of the selected value in

the tempo field.

• Relative Changes the value of the original tempo’s given percentage, which is stored in

the MIDI file.

• Original Defines the original tempo, which is stored in the MIDI file.

5 Transpose song Transposes the current song in + / - 64 half tones.

6 Cue Points At first, this area visually displays the song length. During playback, the

graphic functions as a progress bar, indicating the progress of the song. Vertical lines