Owner`s manual

Reference Section
94
9.26 Functions Menu in the [MIDI file edit] Screen
The functions menu is conventionally located on the screen’s lower right corner. By
clicking there you will get the following options to select from:
1 Filter set Opens the [Set MIDI file view filter] screen in
which you may filter specific events from the events list.
This function is explained under the entry Filter.
2 Filter reset Deletes all set filters and shows all current
files of the MIDI file.
3 Delete all track events Deletes all events from the
selected track
4 Delete all listed events Deletes all displayed events. Use
this function with a personal defined filter. For example, if
you want to delete all aftertouch data, then set the display filter to show only aftertouch
files; then select the function described here.
5 Insert new event Adds a new event. After selecting this function an additional menu will
open where you can select the following events:
• Tempo Change
• Signature...
• Program Change
• Program Note...
• Lyric event...
After selecting one entry from this list, the [Edit MIDI file event] screen will open. You
will get access to all parameter that allow you to perform changes to the corresponding
event. If you want to make any change in this window, exit the screen with OK. If you
want to delete the action, select Cancel.
Please notice that the position in the event list depends on the measure position that you input for the event, when
adding events. AT first, this may seem confusing, since it could happen that the new event would be outside of the visible
area of the list. The only way to see the event in this case is by scrolling down the screen.
6 Add new track... Inserts a complete (empty) MIDI track.