Owner`s manual

....

Working with the Patch List

5 What you see here is your new patch list, which is still empty because you have not loaded

any files to it.

6 Now, save the patch list. For this, select [Func] > Patch File > Save. The following

message will pop up: “Patch File saved OK“.

7.7 Composing Songs to a program

Now you may start to fill the patch list with songs. Proceed with the following steps:

1 If you have switched the power off, load the newly created patch list first. For this, select

[Func] > Patch File > Open.... Search then for the patch list with the name you just gave.

You can recognize patch lists by their ending *.pch. If you have not chosen any other

location, the patch list should be located in the hdd folder. You will also find the standard

patch list with the name PATCHF.PCH there. In case you would like to go back to this

patch list you just have to load it.

After switching the power on, the standard patch list will be loaded automatically. This information is stored in the setup

as standard patch list. How to change this into your own patch list will be explained in chapter 7.10 - Loading a specific

patch list automatically - on page 38.

2 Now, load the MIDI files (or even audio files) of your choice to the patches. For this,

select the desired patch number (you may also start with patch 1) and press

[ENTER/YES]. In regard to the patch number you do not have to make a final decision,

you may still change the sequence of the patches anytime.

3 Select [drives] and search through the folder with your MIDI files. Highlight the file that

you want to load.

4 Select [Open]. The file will be loaded and recorded to the patch list. You will recognize

this by the fact that the song title is displayed in the title line.

5 Load additional titles by skipping with the [FWD] key to the next patch and by repeating

the procedure. When you have loaded all titles of your choice, press the [PERF] key to

see the updated patch list.

6 Save the patch list now by selecting [Func] > Patch File > Save.

Always remember that you have to save the patch list explicitly after performing any kind of changes.