Owner`s manual

Reference Section
154
In this window you have the the following options:
1 Port Set the port to receive the MIDI signal to switch the patches here.
2 Channel Define the MIDI channel to receive the MIDI signal to switch the patches.
3 ModeBankSel: Displays the method used to define the layer and the bank to be activated
by the received MIDI program change.
• Layer X/bankY Layer and bank will be set directly.
• Layer X/bank (man.) Only the program in the currently selected bank of the related
layer will be switched.
• Controller 0/32 Via a bank select command (controller 0 and 32) which precedes the
program change command the layer and the bank are defined. The value of controller 0
sets the layer directly (1..8=Layer 1..8, 9=Player). The value of controller 32 sets the
bank.
After you´ve performed your settings, confirm them with [Yes]. To cancel the operation click [No]. The warning „To
apply this change please exit setup and turn device OFF and ON.“ appears. Click on [OK] and obey the following
instructions.
4 Stream Priority Sets the order of sending the data of the „Send MIDI Stream“ function
and „Vo l u me c on t r o l “ and „Program change“ when activating the patches.
• Stream Priority Enabled The Data of the „Send MIDI Stream“ funtion will be sent
first followed by program change and volume.
• Disabled Program change and volume will be sent first followed by „Send MIDI
Stream“.
16.3.1 Input devices
In this area all inputs of the Multistation can be named. This makes sense if your setup rarely changes and the same
devices are always connected to the inputs anyway. To name an input first of all mark the corresponding entry in the
selection list on the left side of the screen. Then click the [Edit] button on the right and enter a name by the screen key-
pad. Confirm your entry by [OK].
16.3.2 Output devices
In this you can name all outputs of the Multistation. This makes sense if your setup rarely changes and the same
devices are always connected to the outputs anyway. To name an output first of all mark the corresponding entry in the
selection list on the left side of the screen. Then click the [Edit] button on the right and enter a name by the screen key-
pad. Confirm your entry by [OK].