Owner`s manual

Reference Section
152
case, enter here a time span that has to pass until the first access. (This is not necessary
for the standard hard disks.)
• Video standard Switches between PAL (Europe) and NTSC (worldwide standard)
• Set System Default Sets the complete system to the original configuration if you press
the [Enter] key on the operation panel of the remote controller.
16.1.1 Lock Device
• Lock Device Locks the remote controller for further inputs. Only a password will
allow to unlock it again. Switch here between Enabled (locked) and Disabled
(unlocked). To lock, select enabled and confirm the security question (“Are you
sure...”) with YES. Afterwards you are asked for a password. Enter here any desired
combination of numbers. Use this function, for example, to avoid unauthorized people
to access the MULTISTATION during an intermission.
• Change Password You may change the password for lock/unlock the remote control
here. Press the [Enter/Yes] key and enter the old password (the old number). Confirm
your entry by clicking [Enter/Yes]. Then enter a new combination of numbers and
again confirm by [Enter/Yes]. Afterwards the Multistation asks you to reenter the
password. Do so and confirm with [Enter/Yes]. Thus the password has been changed.
16.1.2 Write Lock Device
• Enable Lock Activates the write protection and prevents to save any changes with
„save“. Use this function to make sure that nobody can overwrite and save your data.
• Change Passwort Changes the password for the write lock.
16.2 Audio
• Headroom (dB) Changes the headroom of the digital mixer.
• Master Volume (dB) Changes the master volume of the mixer.
• Master Panning (%) Changes the panning of the master.
• Headphones attenuation in dB Changes the attenuation of the loudspeaker outputs.
• Monitor (INs/OUTs) Switches the peak display on the MULTISTATIONS’ front
panel (between displaying peaks in input and displaying peaks in output)
• Peak hold Enables the peak-hold-function.