Owner`s manual

....
Mixer Module
145
By putting a check mark on the selection fields of this screen, all of the corresponding channels will be routed to each
output. Use this function if you want to send all channels of a specific audio part at once to one output, or if you want
to change an output assignment completely. You have the following options:
1 The upper button indicates the name of the corresponding audio area. When selecting it,
the MULTISTATION will switch back to the corresponding mixer screen. The result is
the same as if you would select the [Mixer] button in the button line.
2 The selection field 1/2 routes the signal to the line outputs 1 and 2.
3 The selection field 3/4 routes the signal to the line outputs 3 and 4.
4 The selection field Eff1 routes the signal to the effect processor 1.
5 The selection field Eff2 routes the signal to the effect processor 2.
6 If the selection field Auto is marked, Synth A and Synth B of the Multistation react to
MIDI commands contained in a Standard MIDI File e.g. controller 91 (Reverb) and cont-
roller 93 (Chorus).
If in the above screen you want to delete all routings for the tracks area completely, then remove the check mark in the
selection field 1/2. Afterwards the following security question will appear: “Some of single channels are routed to
selected output. Do you want to unroute them all?” Select Yes to confirm the procedure, select No to abort the
procedure.