Owner`s manual

Reference Section
144
This screen allows you to configure the routing for the outgoing signals of the line inputs of the MULTISTATION’s
front panel. You have the following options:
1 The upper button indicates the name of the corresponding input. When selecting it, the
MULTISTATION will switch back to the corresponding mixer screen. The result is the
same as if you would select the [Mixer] button in the bottom line.
2 The selection field 1/2 routes the signal to the line outputs 1 and 2.
3 The selection field 3/4 routes the signal to the line outputs 3 and 4.
4 The selection field Eff1 routes the signal to the effect processor 1.
5 The selection field Eff2 routes the signal to the effect processor 2.
11.14 Routing in the [master] Icon
To open this screen, select from the main screen the mixer icon. Then touch the master icon and the [Routing]
button in the bottom line. Afterwards, the following routing screen will open: