Owner`s manual

....
Mixer Module
143
This window allows you to edit the effect. The lower fader (Mix) controls the balance between the original signal and
the effect signal. If you route the effect to an output that otherwise does not have any signal assigned to it, you should
pull the fader to the very right until the entry Wet appears. The pure effect signal will be sent. If the fader is located to
the very left on Dry, it will send only the original signal. Positioning the fader somewhere in-between will lead to an
according mixture.
Effect configuration may also be saved as presets. For this, use the functions menu in the edit screen. You have the
following options there:
1 Load from preset... Loads a previous saved configuration.
2 Save as preset... Saves the current configuration as preset.
11.13 Routing at the [line] Icon
To open this screen, select from the main screen the mixer icon. Then touch the line icon and the [Routing] button
in the bottom line. Afterwards, the following routing screen will open: